DJI to RevoltOSD Wiring Diagram

So you bought the new DJI System and want to connect it to your Flight one controllers. There are a few things you need to know first. Currently this only works on FalcoX, and not all the OSD features are enabled and you must use the Falcox configurator found here to set up the quad. Flightone.com/alpha. If you are using the DJI controller, please make sure it is bound to the air unit before running the setup, or it will not be detected.

This image was done by one of our alpha testers, Nitro. We hope this helps clarify how to connect this system.

Was This Article Helpful?

0
Related Articles
2 Comments
  • Hello. Is it possible to have a wiring diagram for connecting the MillivoltOSD v2 to the DJI Air Unit?

    I dont seem to be getting the OSD or Vbat despite enabling MSP on UART3.

    Completely lost. Need vbat at the least.

Leave a comment

Your email address will not be published. Required fields are marked *