How to connect the camera

The camera signal wire should be wired to the Video IN from Camera pad/pin. The camera can then be powered from either the 5V out and GND pad/pin in the camera connector/pads or can be wired directly to battery voltage from either a free VBAT and GND pad/pin on the flight controller (FC), electronic speed controller (ESC), or the power distribution board (PDB) directly.  At this time camera control has not been implemented.

Was This Article Helpful?

0
Related Articles
0 Comments

There are no comments yet

Leave a comment

Your email address will not be published. Required fields are marked *