Initial Setup of FalcoX, no computer needed

The initial setup of FalcoX assumes you have flashed the board with the latest version of FalcoX and are now ready to setup the board. The more you do this setup, the faster it goes. Nick Willard, aka Wild Willy, has a record of 30 seconds for initial setup! More details will be coming for each specific page. This video was from a very early Alpha firmware so the images may not match exactly but the procedure is the same. If you watch this video, then run the setup on your version you will have a very good understanding of what you are doing!

Was This Article Helpful?

-8
6 Comments

Leave a comment

Your email address will not be published. Required fields are marked *