Installation & Setup

There are no articles

Content Editing

There are no articles


Customization

There are no articles

How To

There are no articles


Latest FAQ

The Celebral AI learning on the H7, what it does and how to use it.

I get video, but the screen is black.

First off lets discuss how the image gets to your goggles! The video signal comes from the camera to the flight controller via the video in pad, then the OSD is overlaid over the image and the combined picture is then sent out the video out pin to the VTX which then transmits the signal to your goggles. If you are receiving a black screen, then that means the VTX is powered, and you are on the right channel in your goggles or monitor. However the VTX is not getting the video signal from your camera! A couple things to check,

  • Is your camera getting power?
  • Check the signal wire from the camera to the FC as well as solder connections. Make sure it is connected to Video IN!
  • Swap to a different camera.

If you can activate and see the OSD, this means the video out from the flight controller is working properly. If you can not get the OSD to open, then the video out from the FC may be the issue.

My video is all snow!

If you are only getting snow for your video this could mean a couple things.

  • 1 VTX is in Pit Mode
  • Goggles are on a different channel then what you have the VTX set to
  • The VTX is not powered.

If the VTX was working and you are on the correct channel, then you would get at least a black screen. For this problem check the goggles and make sure you are on the same channel as the VTX. Make sure the VTX is powered, there should be some kind of indication like a LED on your VTX. Maybe try swapping a different VTX.